Common Analysis and Display Functions
R&S
®
FSW
449User Manual 1173.9411.02 ─ 19
In multiple zoom mode, you can enlarge several different areas of the trace simultane-
ously. An overview window indicates the zoom areas in the original trace, while the
zoomed trace areas are displayed in individual windows. The zoom area that corre-
sponds to the individual zoom display is indicated in the lower right corner, between
the scrollbars.
Remote command:
DISPlay[:WINDow<n>]:ZOOM:MULTiple<zoom>:STATe on page 908
DISPlay[:WINDow<n>]:ZOOM:MULTiple<zoom>:AREA on page 908
Restore Original Display
Restores the original display and closes all zoom windows.
Remote command:
DISPlay[:WINDow<n>]:ZOOM:STATe on page 907 (single zoom)
DISPlay[:WINDow<n>]:ZOOM:MULTiple<zoom>:STATe on page 908 (for each
multiple zoom window)
Deactivating Zoom (Selection mode)
Deactivates zoom mode.
Tapping the screen no longer invokes a zoom, but selects an object.
Remote command:
DISPlay[:WINDow<n>]:ZOOM:STATe on page 907 (single zoom)
DISPlay[:WINDow<n>]:ZOOM:MULTiple<zoom>:STATe on page 908 (for each
multiple zoom window)
7.2.3 How to Zoom Into a Diagram
The remote commands required to zoom into a display are described in chapter 11.8.1,
"Zooming into the Display", on page 907.
The following tasks are described here:
●
"To zoom into the diagram at one position" on page 449
●
"To return to selection mode in the diagram" on page 450
●
"To return to original display" on page 451
●
"To zoom into multiple positions in the diagram" on page 451
To zoom into the diagram at one position
1.
Click on the "Single Zoom" icon in the toolbar.
Zoom mode is activated.
Zoomed Displays
To Next Page
Loading...
