Common Analysis and Display Functions
R&S
®
FSW
493User Manual 1173.9411.02 ─ 19
The squelch function activates the video trigger function (see "Video" on page 428)
and deactivates any other trigger or gating settings. The squelch level and trigger level
are set to the same value. The trigger source in the channel bar is indicated as "SQL"
for squelch. The squelch level is indicated by a red line in the diagram.
7.4.2 Marker Configuration
When working with markers, the following configuration settings and functions are
available:
● Marker Settings.....................................................................................................493
● Marker Search Settings and Positioning Functions.............................................. 498
7.4.2.1 Marker Settings
Marker settings can be configured via the MARKER key or in the "Marker" dialog box.
To display the "Marker" dialog box, do one of the following:
●
Press the MKR key, then select the "Marker Config" softkey.
●
In the "Overview", select "Analysis", and switch to the vertical "Marker" tab.
The remote commands required to define these settings are described in chap-
ter 11.8.3.1, "Setting Up Individual Markers", on page 928.
● Individual Marker Setup........................................................................................ 493
● General Marker Settings....................................................................................... 496
Individual Marker Setup
Up to 17 markers or delta markers can be activated for each window simultaneously.
Initial marker setup is performed using the "Marker" dialog box.
Marker Usage
To Next Page
Loading...
