General Instrument Setup
R&S
®
FSW
576User Manual 1173.9411.02 ─ 19
Save
Saves the currently edited transducer line under the name defined in the "Name" field.
Remote command:
MMEMory:SELect[:ITEM]:TRANsducer:ALL on page 999
MMEMory:STORe:STATe on page 1003
9.3.3 Alignment Settings
Both the instrument and the touchscreen can be aligned when necessary (see chap-
ter 9.1, "Basics on Alignment", on page 565).
The alignment settings are defined in the "Alignment" dialog box which is displayed
when you press the SETUP key and then select "Alignment".
Self-alignment results in secure user mode
Be sure to store self-alignment results before Secure User Mode is enabled; see chap-
ter 3.1.7, "Protecting Data Using the Secure User Mode", on page 37.
If the currently stored self-alignment results are not suitable, you must perform a self-
alignment each time you switch on the R&S FSW in secure user mode, as the results
are not stored permanently in this case.
Starting a Self-alignment.............................................................................................576
Aborting the Self-alignment.........................................................................................577
Starting the Touchscreen Alignment...........................................................................577
Alignment Results....................................................................................................... 577
Starting a Self-alignment
Starts recording correction data for the instrument. If the correction data acquisition
fails or if the correction values are deactivated, a corresponding message is displayed
in the status field.
For details see chapter 9.1, "Basics on Alignment", on page 565.
Note:
General Instrument Settings
To Next Page
Loading...
