Rohde & Schwarz FSW26 - Working with Markers

Remote Commands
R&S
®
FSW
928User Manual 1173.9411.02 ─ 19
TRAC:DATA? TRACE1
//Retrieves the trace data for the selected frame only.
11.8.3 Working with Markers
The commands required to work with markers and marker functions in a remote envi-
ronment are described here. The tasks for manual operation are described in chap-
ter 7.4, "Marker Usage", on page 482.
In the Spectrum application, markers are identical in all windows. Thus, the suffix <n>
for the window is generally irrelevant.
● Setting Up Individual Markers............................................................................... 928
● General Marker Settings....................................................................................... 933
● Configuring and Performing a Marker Search.......................................................934
● Positioning the Marker.......................................................................................... 937
● Retrieving Marker Results.....................................................................................942
● Marker Search (Spectrograms).............................................................................944
● Fixed Reference Marker Settings..........................................................................951
● Marker Peak Lists................................................................................................. 953
● Noise Measurement Marker..................................................................................956
● Phase Noise Measurement Marker.......................................................................956
● Band Power Marker.............................................................................................. 958
● n dB Down Marker................................................................................................ 960
● Signal Count Marker............................................................................................. 963
● Marker Demodulation............................................................................................965
● Programming Examples for Using Markers and Marker Functions.......................967
11.8.3.1 Setting Up Individual Markers
The following commands define the position of markers in the diagram.
CALCulate<n>:DELTamarker:AOFF................................................................................ 929
CALCulate<n>:DELTamarker<m>:LINK........................................................................... 929
CALCulate<n>:DELTamarker<m1>:LINK:TO:MARKer<m2>...............................................929
CALCulate<n>:DELTamarker:MODE............................................................................... 929
CALCulate<n>:DELTamarker<m>:MREF......................................................................... 930
CALCulate<n>:DELTamarker<m>[:STATe].......................................................................930
CALCulate<n>:DELTamarker<m>:TRACe........................................................................930
CALCulate<n>:DELTamarker<m>:X................................................................................ 931
CALCulate<n>:MARKer<m>:AOFF..................................................................................931
CALCulate<n>:MARKer<m1>:LINK:TO:MARKer<m2>.......................................................931
CALCulate<n>:MARKer<m>[:STATe]...............................................................................932
CALCulate<n>:MARKer<m>:TRACe................................................................................932
CALCulate<n>:MARKer<m>:X........................................................................................ 932
Analyzing Measurements (Basics)