Rohde & Schwarz FSW26 - Page 942

Remote Commands
R&S
®
FSW
942User Manual 1173.9411.02 ─ 19
11.8.3.5 Retrieving Marker Results
The following commands are used to retrieve the results of markers.
You can use the marker values to position the center frequency or reference level
directly using the following commands:
● CALCulate<n>:MARKer<m>:FUNCtion:CENTer on page 830
● CALCulate<n>:MARKer<m>:FUNCtion:REFerence on page 844
Useful commands for retrieving results described elsewhere:
● CALCulate<n>:DELTamarker<m>:X on page 931
● CALCulate<n>:MARKer<m>:X on page 932
● CALCulate:MARKer:FUNCtion:FPEaks:COUNt? on page 953
● CALCulate:MARKer:FUNCtion:FPEeaks:X? on page 955
● CALCulate:MARKer:FUNCtion:FPEeaks:Y? on page 955
● CALCulate<n>:MARKer<m>:FUNCtion:NOISe:RESult? on page 956
● CALCulate<n>:DELTamarker<m>:FUNCtion:PNOise:RESult?
on page 957
● CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:RESult?
on page 960
● CALCulate<n>:MARKer<m>:FUNCtion:BPOWer:RESult? on page 958
● CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:RESult? on page 962
● CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:FREQuency? on page 961
● CALCulate:MARKer:FUNCtion:NDBDown:QFACtor? on page 962
● CALCulate<n>:MARKer<m>:COUNt:FREQuency? on page 964
Remote commands exclusive to retrieving marker results
CALCulate<n>:DELTamarker<m>:X:RELative?.................................................................942
CALCulate<n>:DELTamarker<m>:Y?...............................................................................943
CALCulate<n>:MARKer<m>:Y?.......................................................................................943
CALCulate<n>:DELTamarker<m>:X:RELative?
This command queries the relative position of a delta marker on the x-axis.
If necessary, the command activates the delta marker first.
Return values:
<Position> Position of the delta marker in relation to the reference marker or
the fixed reference.
Example:
CALC:DELT3:X:REL?
Outputs the frequency of delta marker 3 relative to marker 1 or
relative to the reference position.
Analyzing Measurements (Basics)