Rohde & Schwarz FSW26 - Page 955

Remote Commands
R&S
®
FSW
955User Manual 1173.9411.02 ─ 19
Parameters:
<SortMode> X
Sorts the peaks according to increasing position on the x-axis.
Y
Sorts the peaks according to decreasing position on the y-axis.
*RST: X
Example:
CALC:MARK:FUNC:FPE:SORT Y
Sets the sort mode to decreasing y values
Manual operation: See "Sort Mode" on page 518
CALCulate<n>:
MARKer<m>:FUNCtion:FPEaks:STAT <State>
This command turns a peak search on and off.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MARK:FUNC:FPE:STAT ON
Activates marker peak search
Manual operation: See "Peak List State" on page 518
CALCulate:MARKer:FUNCtion:FPEeaks:X?
This command queries the position of the peaks on the x-axis.
The order depends on the sort order that has been set with CALCulate<n>:
MARKer<m>:FUNCtion:FPEaks:SORT.
Return values:
<PeakPosition> Position of the peaks on the x-axis. The unit depends on the
measurement.
Usage: Query only
CALCulate:MARKer:FUNCtion:FPEeaks:Y?
This command queries the position of the peaks on the y-axis.
The order depends on the sort order that has been set with CALCulate<n>:
MARKer<m>:FUNCtion:FPEaks:SORT.
Return values:
<PeakPosition> Position of the peaks on the y-axis. The unit depends on the
measurement.
Usage: Query only
Analyzing Measurements (Basics)