General Instrument Setup
R&S
®
FSW
604User Manual 1173.9411.02 ─ 19
Note: Do not switch off the instrument during the reconfiguration process!
Now the firmware update is complete. It is recommended that you perform a self-
alignment after the update (see chapter 9.6.2, "How to Align the Instrument",
on page 602).
9.6.6 How to Configure the Transducer
Configuring the transducer is very similar to configuring limit lines.
The transducer settings are defined in the "Transducer" dialog box which is displayed
when you press the SETUP key and then select "Transducer".
The following tasks are described:
●
"How to find compatible transducer lines" on page 604
●
"How to activate and deactivate a transducer" on page 604
●
"How to edit existing transducer lines" on page 604
●
"How to copy an existing transducer line" on page 605
●
"How to delete an existing transducer line" on page 605
●
"How to configure a new transducer line" on page 605
●
"How to move the transducer line vertically or horizontally" on page 606
How to find compatible transducer lines
► In the "Transducer" dialog box, select the "View filter" option: "Show compatible".
All transducer lines stored on the instrument that are compatible to the current
measurement settings are displayed in the overview.
How to activate and deactivate a transducer
1. To activate a transducer select a transducer line in the overview and select the
"Active" setting for it.
The trace is automatically recalculated for the next sweep after a transducer line is
activated.
2. To deactivate a transducer line, deactivate the "Active" setting for it.
After the next sweep, the originally measured values are displayed.
How to edit existing transducer lines
Existing transducer line configurations can be edited.
1. In the "Transducer" dialog box, select the transducer line.
2. Select the "Edit" button.
3. Edit the line configuration as described in "How to configure a new transducer line"
on page 605.
How to Configure the Basic Instrument Settings
To Next Page
Loading...
