Common Analysis and Display Functions
R&S
®
FSW
464User Manual 1173.9411.02 ─ 19
In the spectrogram result display, you can activate up to 16 markers or delta markers
at the same time. Each marker can be assigned to a different frame. Therefore, in
addition to the frequency you also define the frame number when activating a new
marker. If no frame number is specified, the marker is positioned on the currently
selected frame. All markers are visible that are positioned on a visible frame. Special
search functions are provided for spectrogram markers.
In the spectrum result display, only the markers positioned on the currently selected
frame are visible. In "Continuous Sweep" mode this means that only markers posi-
tioned on frame 0 are visible. To view markers that are positioned on a frame other
than frame 0 in the spectrum result display, you must stop the measurement and select
the corresponding frame.
7.3.2 Trace Configuration
Trace configuration includes the following settings and functions:
● Trace Settings.......................................................................................................464
● Trace Math............................................................................................................469
● Trace / Data Export Configuration.........................................................................470
● Spectrogram Settings............................................................................................472
7.3.2.1 Trace Settings
You can configure the settings for up to 6 individual traces.
Trace settings can be configured via the TRACE key, in the "Traces" dialog box, or in
the vertical "Traces" tab of the "Analysis" dialog box.
For settings on spectrograms, see chapter 7.3.2.4, "Spectrogram Settings",
on page 472.
Trace data can also be exported to an ASCII file for further analysis. For details see
chapter 7.3.2.3, "Trace / Data Export Configuration", on page 470.
Trace Configuration
To Next Page
Loading...
