Rohde & Schwarz FSW26 - Page 469

Common Analysis and Display Functions
R&S
®
FSW
469User Manual 1173.9411.02 ─ 19
7.3.2.2 Trace Math
Trace math settings can be configured via the TRACE key, in the "Trace Math" tab of
the "Traces" dialog box.
Trace Math Function................................................................................................... 469
Trace Math Off............................................................................................................ 470
Trace Math Position.................................................................................................... 470
Trace Math Mode........................................................................................................470
Trace Math Function
Defines which trace is subtracted from trace 1. The result is displayed in trace 1 and
refers to the zero point defined with the Trace Math Position setting. The following sub-
tractions can be performed:
"T1-T2 -> T1" Subtracts trace 2 from trace 1.
"T1-T3 -> T1" Subtracts trace 3 from trace 1
"T1-T4 -> T1" Subtracts trace 4 from trace 1
"T1-T5 -> T1" Subtracts trace 5 from trace 1
"T1-T6 -> T1" Subtracts trace 6 from trace 1
To switch off the trace math, use the Trace Math Off button.
Remote command:
CALCulate<n>:MATH[:EXPression][:DEFine] on page 919
CALCulate<n>:MATH:STATe on page 920
Trace Configuration