Rohde & Schwarz FSW26 - Analyzing Statistics (APD, CCDF)

Remote Commands
R&S
®
FSW
778User Manual 1173.9411.02 ─ 19
CALC:PSE:SUBR 10
//Sets 10 peaks per range to be stored in the list.
//--------------Performing the Measurement-----
INIT:SPUR; *WAI
//Performs a spurious emission measurement and waits until the sweep has finished.
//---------------Retrieving Results-------------
CALC:LIM1:FAIL?
//Queries the result of the check for limit line 1.
TRAC? SPUR
//Queries the peak list of the spurious emission measurement.
11.5.8 Analyzing Statistics (APD, CCDF)
All remote control commands specific to statistical measurements are described here.
● Activating Statistical Measurements..................................................................... 778
● Configuring Statistical Measurements...................................................................779
● Using Gate Ranges for Statistical Measurements................................................ 780
● Scaling the Diagram..............................................................................................782
● Performing a Statistical Measurement.................................................................. 784
● Retrieving Results.................................................................................................784
● Programming Example: Measuring Statistics....................................................... 786
11.5.8.1 Activating Statistical Measurements
The following commands activate statistical measurements.
CALCulate<n>:STATistics:APD[:STATe].......................................................................... 778
CALCulate<n>:STATistics:CCDF[:STATe]........................................................................778
CALCulate<n>:STATistics:APD[:STATe] <State>
This command turns the APD measurement on and off.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:STAT:APD ON
Switches on the APD measurement.
Manual operation: See "APD" on page 113
CALCulate<n>:STATistics:CCDF[:STATe] <State>
This command turns the CCDF on and off.
Configuring and Performing Measurements