Common Analysis and Display Functions
R&S
®
FSW
440User Manual 1173.9411.02 ─ 19
7 Common Analysis and Display Functions
General methods and basic settings to display and analyze measurements, regardless
of the operating mode, are described here. If you are performing a specific measure-
ment task, using an operating mode other than Signal and Spectrum Analyzer mode,
or an application other than the Spectrum application, be sure to check the specific
application or mode description for settings and functions that may deviate from these
common settings.
The analysis settings and functions are available via the "Analysis" dialog box, which is
displayed when you select the "Analysis" button in the "Overview". Additional measure-
ment-specific analysis functions may be available in separate tabs in the "Analysis"
dialog box. These are described with the individual measurements.
See chapter 5, "Measurements", on page 110.
● Result Display Configuration.................................................................................440
● Zoomed Displays.................................................................................................. 447
● Trace Configuration...............................................................................................451
● Marker Usage........................................................................................................482
● Display and Limit Lines......................................................................................... 523
7.1 Result Display Configuration
Measurement results can be evaluated in many different ways, for example graphi-
cally, as summary tables, statistical evaluations etc. Thus, the result display is highly
configurable to suit your specific requirements and optimize analysis. Here you can
find out how to optimize the display for your measurement results.
Basic operations concerning the R&S FSW display, for example how to use the Smart-
Grid, are described in the R&S FSW Getting Started manual.
General display settings that are usually configured during initial instrument setup,
independently of the current measurement, e.g. which items or colors are displayed on
the screen, are described in chapter 9.4, "Display Settings", on page 590.
● Basic Evaluation Methods.....................................................................................440
● Laying out the Result Display with the SmartGrid.................................................442
7.1.1 Basic Evaluation Methods
Measurement results can be displayed and evaluated using various different methods,
also at the same time. Depending on the currently selected measurement, in particular
when using optional firmware applications, not all evaluation methods are available.
The evaluation methods described here are available for most measurements in the
Spectrum application.
Result Display Configuration
To Next Page
Loading...
