Common Analysis and Display Functions
R&S
®
FSW
441User Manual 1173.9411.02 ─ 19
Diagram.......................................................................................................................441
Marker Table...............................................................................................................441
Marker Peak List......................................................................................................... 441
Result Summary..........................................................................................................442
Spectrogram................................................................................................................442
Diagram
Displays a basic level vs. frequency or level vs. time diagram of the measured data to
evaluate the results graphically. This is the default evaluation method. Which data is
displayed in the diagram depends on the "Trace" settings. Scaling for the y-axis can be
configured.
See chapter 7.3, "Trace Configuration", on page 451 and chapter 6.4.3, "Scaling the
Y-Axis", on page 399.
Remote command:
LAY:ADD? '1',RIGH, DIAG, see LAYout:ADD[:WINDow]? on page 822
Marker Table
Displays a table with the current marker values for the active markers.
This table may be displayed automatically if configured accordingly (see "Marker Table
Display" on page 497).
Remote command:
LAY:ADD? '1',RIGH, MTAB, see LAYout:ADD[:WINDow]? on page 822
Results:
CALCulate<n>:MARKer<m>:X on page 932
CALCulate<n>:MARKer<m>:Y? on page 943
Marker Peak List
The marker peak list determines the frequencies and levels of peaks in the spectrum or
time domain. How many peaks are displayed can be defined, as well as the sort order.
In addition, the detected peaks can be indicated in the diagram. The peak list can also
be exported to a file for analysis in an external application.
Result Display Configuration
To Next Page
Loading...
