Rohde & Schwarz FSW26 - General Instrument Settings; Reference Frequency Settings

General Instrument Setup
R&S
®
FSW
568User Manual 1173.9411.02 ─ 19
9.3 General Instrument Settings
Instrument settings can be configured via the SETUP key.
Network and Remote Settings, Display Settings
Settings for network and remote operation are described in chapter 10, "Network and
Remote Operation", on page 609.
Display settings are described in chapter 9.4, "Display Settings", on page 590.
● Reference Frequency Settings..............................................................................568
● Transducer Settings..............................................................................................571
● Alignment Settings................................................................................................ 576
● System Configuration Settings..............................................................................577
● Service Functions..................................................................................................583
9.3.1 Reference Frequency Settings
The reference frequency settings are defined in the "Reference" dialog box which is
displayed when you press the SETUP key and then select "Reference".
Reference Frequency Input.........................................................................................569
└ Behavior in case of missing external reference............................................ 570
└ Tuning Range............................................................................................... 570
General Instrument Settings