Remote Commands
R&S
®
FSW
960User Manual 1173.9411.02 ─ 19
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:MODE <Mode>
This command selects the way the results for a band power delta marker are dis-
played.
Parameters:
<Mode> POWer
Result is displayed as a power in dBm.
DENSity
Result is displayed as a density in dBm/Hz.
*RST: POWer
CALCulate<n>:
DELTamarker<m>:FUNCtion:BPOWer:RESult?
This command queries the results of the band power measurement.
Return values:
<Power> Signal power over the delta marker bandwidth.
Usage: Query only
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:SPAN <Span>
This command defines the bandwidth around the delta marker position.
Parameters:
<Span> Frequency. The maximum span depends on the marker position
and R&S FSW model.
*RST: 5% of current span
Default unit: Hz
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer[:STATe] <State>
This command turns delta markers for band power measurements on and off.
If neccessary, the command also turns on a reference marker.
Parameters:
<State> ON | OFF
*RST: OFF
11.8.3.12 n dB Down Marker
The following commands control the n dB down markers.
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown............................................................ 961
CALCulate<n>:MARKer<m>:FUNCtion:NDBDown:FREQuency?........................................961
CALCulate:MARKer:FUNCtion:NDBDown:QFACtor?.........................................................962
Analyzing Measurements (Basics)
To Next Page
Loading...
