Rohde & Schwarz FSW26 - Page 933

Remote Commands
R&S
®
FSW
933User Manual 1173.9411.02 ─ 19
Manual operation: See "Marker 1/2/3/4" on page 282
See "Marker 1/2/3" on page 287
See "Marker Position (X-value)" on page 299
See "Marker Table" on page 441
See "Marker Peak List" on page 441
11.8.3.2 General Marker Settings
The following commands control general marker functionality.
Remote commands exclusive to general marker functionality
DISPlay:MTABle............................................................................................................ 933
CALCulate:MARKer:X:SSIZe.......................................................................................... 933
DISPlay:MTABle <DisplayMode>
This command turns the marker table on and off.
Parameters:
<DisplayMode> ON
Turns the marker table on.
OFF
Turns the marker table off.
AUTO
Turns the marker table on if 3 or more markers are active.
*RST: AUTO
Example:
DISP:MTAB ON
Activates the marker table.
Manual operation: See "Marker Table Display" on page 497
CALCulate:MARKer:X:SSIZe <StepSize>
This command selects the marker step size mode.
The step size defines the distance the marker moves when you move it with the rotary
knob. It therefore takes effect in manual operation only.
Parameters:
<StepSize> STANdard
the marker moves from one pixel to the next
POINts
the marker moves from one sweep point to the next
*RST: POINts
Example:
CALC:MARK:X:SSIZ STAN
Sets the marker step size to one pixel.
Manual operation: See "Marker Stepsize" on page 497
Analyzing Measurements (Basics)