Remote Commands
R&S
®
FSW
981User Manual 1173.9411.02 ─ 19
Parameters:
<Offset> Numeric value.
*RST: 0
Default unit: dB
Manual operation: See "Y-Offset" on page 531
CALCulate:LIMit<k>:LOWer:SHIFt <Distance>
This command moves a complete lower limit line vertically.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Parameters:
<Distance> Defines the distance that the limit line moves.
The unit depends on CALCulate:LIMit<k>:UNIT
on page 982.
Manual operation: See "Shift y" on page 534
CALCulate:LIMit<k>:LOWer:SPACing <InterpolType>
This command selects linear or logarithmic interpolation for the calculation of a lower
limit line from one horizontal point to the next.
Parameters:
<InterpolType> LINear | LOGarithmic
*RST: LIN
Manual operation: See "X-Axis" on page 533
See "Y-Axis" on page 533
CALCulate:LIMit<k>:LOWer:STATe <State>
This command turns a lower limit line on and off.
Before you can use the command, you have to select a limit line with CALCulate:
LIMit<k>:NAME on page 982.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: SCPI confirmed
Manual operation: See "Visibility" on page 530
CALCulate:LIMit<k>:LOWer:THReshold <Threshold>
This command defines a threshold for relative limit lines.
Analyzing Measurements (Basics)
To Next Page
Loading...
