Common Analysis and Display Functions
R&S
®
FSW
531User Manual 1173.9411.02 ─ 19
This setting does not have any effect on limit lines that are defined by absolute values
for the x-axis.
Remote command:
CALCulate:LIMit<k>:CONTrol:OFFSet on page 979
Y-Offset
Shifts a limit line that has relative values for the y-axis (levels or linear units such as
volt) vertically.
This setting does not have any effect on limit lines that are defined by absolute values
for the y-axis.
Remote command:
CALCulate:LIMit<k>:LOWer:OFFSet on page 980
CALCulate:LIMit<k>:UPPer:OFFSet on page 983
Create New Line
Creates a new limit line.
Edit Line
Edit an existing limit line configuration.
Copy Line
Copy the selected limit line configuration to create a new line.
Remote command:
CALCulate:LIMit<k>:COPY on page 985
Delete Line
Delete the selected limit line configuration.
Remote command:
CALCulate:LIMit<k>:DELete on page 985
Disable All Lines
Disable all limit lines in one step.
Remote command:
CALCulate:LIMit<k>:STATe on page 986
Limit Line Details
Limit lines details are configured in the "Edit Line Line" dialog box which is displayed
when you select the "New", "Edit" or "Copy To" buttons in the "Line Config" dialog box.
Display and Limit Lines
To Next Page
Loading...
