Remote Commands
R&S
®
FSW
986User Manual 1173.9411.02 ─ 19
Manual operation: See "Delete Line" on page 531
CALCulate:LIMit<k>:STATe <State>
This command turns the limit check for a specific limit line on and off.
To query the limit check result, use CALCulate:LIMit<k>:FAIL?.
Note that a new command exists to activate the limit check and define the trace to be
checked in one step (see CALCulate:LIMit<k>:TRACe<t>:CHECk on page 986).
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:LIM:STAT ON
Switches on the limit check for limit line 1.
Usage: SCPI confirmed
Manual operation: See "Disable All Lines" on page 531
CALCulate:LIMit<k>:TRACe<t>:CHECk <State>
This command turns the limit check for a specific trace on and off.
To query the limit check result, use CALCulate:LIMit<k>:FAIL?.
Note that this command replaces the two commands from previous signal and spec-
trum analyzers (which are still supported, however):
● CALCulate:LIMit<k>:TRACe on page 1085
● CALCulate:LIMit<k>:STATe on page 986
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:LIM3:TRAC2:CHEC ON
Switches on the limit check for limit line 3 on trace 2.
Manual operation: See "Traces to be Checked" on page 530
Checking the Results of a Limit Check
CALCulate:LIMit:CLEar[:IMMediate].................................................................................986
CALCulate:LIMit<k>:FAIL?..............................................................................................987
CALCulate:LIMit:CLEar[:IMMediate]
This command deletes the result of the current limit check.
The command works on all limit lines in all measurement windows at the same time.
Analyzing Measurements (Basics)
To Next Page
Loading...
