Remote Commands
R&S
®
FSW
881User Manual 1173.9411.02 ─ 19
11.7.6.3 Setting up Probes
Probes can be connected to the optional BASEBAND INPUT connectors, if the Analog
Baseband interface ( option R&S FSW-B71) is installed.
[SENSe:]PROBe<p>:ID:PARTnumber?............................................................................881
[SENSe:]PROBe<p>:ID:SRNumber?............................................................................... 881
[SENSe:]PROBe<p>:SETup:MODE.................................................................................881
[SENSe:]PROBe<p>:SETup:NAME?............................................................................... 882
[SENSe:]PROBe<p>:SETup:STATe?...............................................................................882
[SENSe:]PROBe<p>:SETup:TYPE?................................................................................ 883
[SENSe:]PROBe<p>:ID:PARTnumber?
Queries the R&S part number of the probe.
Suffix:
<p>
.
1 | 2 | 3
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF (currently not supported; use "1" with RF Input Connec-
tor setting "Baseband Input I")
Return values:
<PartNumber> Part number in a string.
Usage: Query only
[SENSe:]PROBe<p>:ID:SRNumber?
Queries the serial number of the probe.
Suffix:
<p>
.
1 | 2 | 3
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF (currently not supported; use "1" with RF Input Connec-
tor setting "Baseband Input I")
Return values:
<SerialNo> Serial number in a string.
Usage: Query only
[SENSe:]PROBe<p>:SETup:MODE <Mode>
Select the action that is started with the micro button on the probe head.
See also: "Microbutton Action" on page 321.
Setting Basic Measurement Parameters
To Next Page
Loading...
