Rohde & Schwarz FSW26 - Page 947

Remote Commands
R&S
®
FSW
947User Manual 1173.9411.02 ─ 19
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MINimum:ABOVe
This command moves a marker vertically to the next higher minimum level for the cur-
rent frequency.
The search includes only frames above the current marker position. It does not change
the horizontal position of the marker.
Usage: Event
Manual operation: See "Search Mode for Next Peak in Y Direction" on page 502
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MINimum:BELow
This command moves a marker vertically to the next higher minimum level for the cur-
rent frequency.
The search includes only frames below the current marker position. It does not change
the horizontal position of the marker.
Usage:
Event
Manual operation: See "Search Mode for Next Peak in Y Direction" on page 502
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MINimum:NEXT
This command moves a marker vertically to the next higher minimum level for the cur-
rent frequency.
The search includes all frames. It does not change the horizontal position of the
marker.
Usage:
Event
Manual operation: See "Search Mode for Next Peak in Y Direction" on page 502
CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:Y:MINimum[:PEAK]
This command moves a marker vertically to the minimum level for the current fre-
quency.
The search includes all frames. It does not change the horizontal position of the
marker.
If the marker hasn't been active yet, the command first looks for the peak level for all
frequencies and moves the marker vertically to the minimum level.
Usage:
Event
Manual operation: See "Marker Search Type" on page 503
Using Delta Markers
The following commands control spectrogram delta markers.
Analyzing Measurements (Basics)