Measurements
R&S
®
RTM20xx
95User Manual 1317.4726.02 ─ 01
Meas. Place..................................................................................................................95
Measure 1-4..................................................................................................................95
Meas. Type...................................................................................................................95
Source...........................................................................................................................96
Statistic..........................................................................................................................96
└ Meas. Place....................................................................................................96
└ Statistic...........................................................................................................96
└ No. of Averages..............................................................................................96
└ Reset, Reset All..............................................................................................96
└ Clear All..........................................................................................................96
Reference Level: Upper, Middle, Lower Levels............................................................97
Clear All.........................................................................................................................97
Delay Setup...................................................................................................................97
Phase Setup..................................................................................................................97
Meas. Place
Selects one of the four available measurements to be configured or activated.
Measure 1-4
Activates or deactivates the selected measurement (1-4).
Remote command:
MEASurement<m>[:ENABle] on page 336
Meas. Type
Defines the measurement type to be performed on the selected source. Depending on
the type, different results are displayed in the result table.
For a list of all automatic measurement types and their description, see chapter 6.3.1,
"Measurement Types and Results", on page 87.
Remote command:
MEASurement<m>:MAIN on page 336
MEASurement<m>:RESult[:ACTual]? on page 340
Automatic Measurements
To Next Page
Loading...
