Remote Control
R&S
®
RTM20xx
422User Manual 1317.4726.02 ─ 01
● LIN - Configuration................................................................................................422
● LIN - Trigger..........................................................................................................423
● LIN - Decode Results............................................................................................426
● LIN - Search..........................................................................................................431
LIN - Configuration
BUS<b>:LIN:DATA:SOURce...........................................................................................422
BUS<b>:LIN:POLarity.....................................................................................................422
BUS<b>:LIN:STANdard..................................................................................................422
BUS<b>:LIN:BITRate.....................................................................................................423
CHANnel<m>:THReshold:FINDlevel................................................................................423
BUS<b>:LIN:DATA:SOURce <Source>
Sets the source of the data line. All channel waveforms can be used.
Suffix:
<b>
.
1..4
Selects the bus.
Parameters:
<Source> CH1 | CH2 | CH3 | CH4 | D0..D15
*RST: CH1
BUS<b>:LIN:POLarity <Polarity>
Defines the idle state of the bus. The idle state is the rezessive state and corresponds to
a logic 1.
Suffix:
<b>
.
1..4
Selects the bus.
Parameters:
<Polarity> IDLHigh | IDLLow
IDLHigh: Low active, negative polarity
IDLLow: High active, positive polarity
*RST: IDLL
BUS<b>:LIN:STANdard <Standard>
Selects the version of the LIN standard that is used in the DUT. The setting mainly defines
the checksum version used during decoding.
The most common version is LIN 2.x. For mixed networks, or if the standard is unknown,
set the LIN standard to AUTO.
Suffix:
<b>
.
1..4
Selects the bus.
Command Reference
To Next Page
Loading...
