Rohde & Schwarz RTM2032 - Page 438

Remote Control
R&S
®
RTM20xx
423User Manual 1317.4726.02 ─ 01
Parameters:
<Standard> V1X | V2X | J2602 | AUTO
*RST: V1X
BUS<b>:LIN:BITRate <BitRate>
Sets the number of transmitted bits per second.
Suffix:
<b>
.
1..4
Selects the bus.
Parameters:
<BitRate> *RST: 9,60E+003
Default unit: Bit/s
CHANnel<m>:THReshold:FINDlevel
Executes the analysis of all analog channels that are configured for the selected bus and
sets the threshold for digitization of analog signals for each channel.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Usage: Event
LIN - Trigger
TRIGger:A:LIN:TYPE.....................................................................................................423
TRIGger:A:LIN:CHKSerror..............................................................................................424
TRIGger:A:LIN:IPERror..................................................................................................424
TRIGger:A:LIN:SYERror.................................................................................................424
TRIGger:A:LIN:ICONdition..............................................................................................425
TRIGger:A:LIN:IDENtifier................................................................................................425
TRIGger:A:LIN:DATA.....................................................................................................425
TRIGger:A:LIN:DCONdition.............................................................................................425
TRIGger:A:LIN:DLENgth.................................................................................................426
TRIGger:A:LIN:TYPE <TriggerType>
Specifies the trigger mode for LIN.
Command Reference