Welcome to the 5G New Radio Option
R&S
®
SMW-K144
11User Manual 1178.8013.02 ─ 06
To play back a signal from a waveform file created by the simulation software
R&S WinIQSIM2, the corresponding R&S WinIQSIM2 digital standard option must be
installed.
2.1 Accessing the 5G New Radio Dialog
To open the dialog with 5G New Radio settings
► In the block diagram of the R&S SMW, select "Baseband > 5G NR".
A dialog box opens that displays the provided general settings.
The signal generation is not started immediately. To start signal generation with the
default settings, select "State > On".
2.2 Scope
Tasks (in manual or remote operation) that are also performed in the base unit in the
same way are not described here.
In particular, it includes:
●
Managing settings and data lists, like storing and loading settings, creating and
accessing data lists, or accessing files in a particular directory.
●
Information on regular trigger, marker and clock signals and filter settings, if appro-
priate.
●
General instrument configuration, such as checking the system configuration, con-
figuring networks and remote operation
●
Using the common status registers
For a description of such tasks, see the R&S SMW user manual.
2.3 Notes on Screenshots
When describing the functions of the product, we use sample screenshots. These
screenshots are meant to illustrate as many as possible of the provided functions and
possible interdependencies between parameters. The shown values may not represent
realistic usage scenarios.
The screenshots usually show a fully equipped product, that is: with all options instal-
led. Thus, some functions shown in the screenshots may not be available in your par-
ticular product configuration.
Notes on Screenshots
To Next Page
Loading...