Rohde & Schwarz SMW-K144 - Carrier Mapping Commands

Remote-Control Commands
R&S
®
SMW-K144
182User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:DUMRes:PATTern <Pattern>,
<BitCount>
Sets a bit pattern as a data source.
Parameters:
<Pattern> numeric
*RST: #H0
<BitCount> integer
Range: 1 to 64
*RST: 1
Example: See Example "Filling in the frame with dummy REs"
on page 150.
Manual operation: See "Data Source" on page 42
8.7 Carrier Mapping Commands
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:CELL[:ROW<ch0>]...................................182
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:MAPPed[:ROW<ch0>]..............................182
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:AP4000[:ROW<ch0>]............................... 183
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:DFReq[:ROW<ch0>].................................183
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:CELL[:ROW<ch0>]
<MapCellNum>
Queries which of the carriers is output at which baseband.
Parameters:
<MapCellNum> integer
Indicates the carrier.
Carriers are numbered automatically, where the maximum num-
ber of carriers is set with the command [:SOURce<hw>]:BB:
NR5G:NODE:NCARrier.
The number of available carriers and their default mapping to
the available basebands depends on the selected system con-
figuration.
Range: 0 to 15
*RST: 0
Example: See Example "Mapping the carriers to the outputs" on page 150.
Manual operation: See "Carrier" on page 44
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:MAPPed[:ROW<ch0>]
<CellMapped>
If enabled, the signal of the selected cell is mapped to the output.
Carrier Mapping Commands