Rohde & Schwarz SMW-K144 - NZP CSI-RS Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
65User Manual 1178.8013.02 ─ 06
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:ZP:SET<gr0>:RES<user0>:DENSity on page 198
CDM-Type ← Periodic/aperiodic ZP CSI-RS resource table
Indicates or sets value of the higher-layer parameter cdm-Type in the
CSI-RS-ResourceMapping.
The value is selected automatically according to TS 38.211 and depending on the
selected "Row" on page 64.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:ZP:SET<gr0>:RES<user0>:CDMType? on page 198
Bitmap ← Periodic/aperiodic ZP CSI-RS resource table
Sets the location of the ZP CSI-RS in the frequency domain, where the starting posi-
tion and number of the resource blocks in which the CSI-RS is transmitted are defined
by the higher-layer parameters freqBand.
This parameter is transmitted by the higher-layer parameters
frequencyDomainAllocation as part of the CSI-RS-ResourceMapping or the
CSI-RS-CellMobility messages.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:ZP:SET<gr0>:RES<user0>:BITMap on page 199
l0/l1 ← Periodic/aperiodic ZP CSI-RS resource table
Sets the parameters l
0
and l
1
and define the ZP CSI-RS location relative to the start of
as slot. Thus, the l
0
and l
1
give the location of the CSI-RS in time.
Thess parameters are transmitted by the higher-layer parameters
firstOFDMSymbolInTimeDomain and firstOFDMSymbolInTimeDomain2 as
part of the CSI-RS-ResourceMapping or the CSI-RS-CellMobility messages.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:ZP:SET<gr0>:RES<user0>:I0 on page 199
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
CSIRs:ZP:SET<gr0>:RES<user0>:I1 on page 199
5.3.4.4 NZP CSI-RS Settings
Access:
► Select "User/BWP Settings > DL BWP Config > NZP CSI-RS".
The dialog comprises the non-zero-power (NZP) CSI-RS settings, as defined in TS
38.211.
Users/BWPs Settings