Rohde & Schwarz SMW-K144 - Transmission Bandwidth (Txbw) Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
33User Manual 1178.8013.02 ─ 06
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SUL:STATe on page 169
5.2.3 Transmission Bandwidth (TxBW) Settings
Access:
1. Select "5G New Radio > General > Link Direction > Downlink".
2. Select "5G New Radio > General > Node > TxBW".
This dialog comprises the settings, related to the transmission bandwidths (TxBW).
These include: the frequency offset between the center carrier and the Point A, the
transmission bandwidth width in number of RBs and the k
0
μ
.
Settings:
Cell................................................................................................................................33
Point A to Carrier Center...............................................................................................33
Resolve Conflicts.......................................................................................................... 34
TxBW table....................................................................................................................34
└ SCS.................................................................................................................34
└ Use..................................................................................................................34
└ N_RB.............................................................................................................. 34
└ TxBW Offset....................................................................................................34
└ k0u.................................................................................................................. 35
Cell
Selects/indicates to which carrier/cell the settings apply.
Remote command:
via suffix at CELL<ch>
Point A to Carrier Center
Sets the frequency offset between the reference Point A and the center carrier fre-
quency.
The Point A is the reference point for the frequency-dependent parameters, for exam-
ple TxBW Offset and RB Offset/RB Offset (15 kHz SCS)/RB Offset (60 kHz SCS).
Node Settings