Rohde & Schwarz SMW-K144 - General Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
88User Manual 1178.8013.02 ─ 06
5.5.1 General Settings
Access:
1. Select "Scheduling > User x BWP x > Content > PDSCH/PUSCH > Settings > Con-
fig".
2. Select "General".
Settings:
PDSCH Type/PUSCH Type.......................................................................................... 88
Number of Codewords.................................................................................................. 88
Scheduled by CORESET 0...........................................................................................89
Modulation.....................................................................................................................89
Phys. Bits...................................................................................................................... 89
PDSCH Type/PUSCH Type
Defines the PDSCH/PUSCH type by selecting the DCI format by that the PDSCH/
PUSCH content is defined.
The available settings depend on the current configuration. To select, for example,
"PDSCH Type = DCI Format 1_0", select"Users/BWP > DL BWP Config > PDSCH >
Additional Position Index = 2" and "Scheduling > PDSCH > Map Type = A".
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh|PUSCh:TYPE on page 220
Number of Codewords
For PDSCH, sets if one or two codewords are used.
The combination of number of codewords and Number of Layers determines the layer
mapping for the selected precoding scheme.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh:NCW on page 220
PDSCH/PUSCH Settings