Rohde & Schwarz SMW-K144 - 5.5 PDSCH;PUSCH Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
86User Manual 1178.8013.02 ─ 06
"Config"
Opens the dialogs for configuration of the corresponding settings.
See:
●
Chapter 5.2.4, "SS/PBCH Settings", on page 35
●
Chapter 5.2.5, "Dummy REs Settings", on page 41
●
Chapter 5.3.3, "DL/UL BWPs Settings", on page 51
●
Chapter 5.5, "PDSCH/PUSCH Settings", on page 86
●
Chapter 5.6, "CORESET Settings", on page 100
●
Chapter 5.7, "PUCCH Settings", on page 117
Remote command:
n.a.
Power
Sets the power for the selected allocation relative to the power of the other allocations.
Allocations with "Power = 0 dB" use the same power level.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:POWer on page 218
State
Sets the allocation to active or inactive state.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:STATe on page 218
Repetition
●
Configurable allocations
Defines if and how the allocation is repeated, e.g. per slot, per subframe on or on a
per frame basis.
●
Read-only allocations
Indicates the read-only reason, e.g. ongoing allocation, from SF#, etc.
Select this indication to access the setting that causes the configuration.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:REPetitions on page 218
5.5 PDSCH/PUSCH Settings
Access:
1. PDSCH settings:
a) Select "5G New Radio > General > Link Direction > Downlink".
b) Select "5G New Radio > Scheduling".
c) Select "User x BWP x > Content > PDSCH".
PDSCH/PUSCH Settings