Rohde & Schwarz SMW-K144 - PTRS Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
95User Manual 1178.8013.02 ─ 06
Settings:
Number of ACK Bits......................................................................................................95
ACK Pattern.................................................................................................................. 95
Number of CSI x Bits.....................................................................................................95
CSI x Pattern.................................................................................................................95
Number of ACK Bits
Sets the number of ACK bits and defines the length of the "ACK Pattern" field.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:ACK:BITS on page 228
ACK Pattern
Sets the ACK bits in pattern form, where the pattern length is set with the parameter
"Number of ACK Bits".
A "1" indicates an ACK, a "0" - a NACK.
The pattern is read out once.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:ACK:PATTern on page 228
Number of CSI x Bits
Sets the number of CSI 1/CSI 2 bits and defines the length of the "CSI Pattern" fields.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI1:BITS on page 228
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI2:BITS on page 228
CSI x Pattern
Sets the CSI bits in pattern form, where the pattern length is set with the parameter
"Number of CSI x Bits".
A "1" indicates an ACK, a "0" - a NACK.
The pattern is read out once.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI1:PATTern on page 228
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI2:PATTern on page 228
5.5.6 PTRS Settings
Access:
1. Select "Scheduling > User x BWP x > Content > PDSCH > Settings > Config".
PDSCH/PUSCH Settings