Rohde & Schwarz SMW-K144 - Page 228

Remote-Control Commands
R&S
®
SMW-K144
228User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI1:BITS <PuschUciCSI1Bit>
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI2:BITS <PuschUCICSI2Bit>
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:ACK:BITS <PuschUciAckBit>
Sets the number of ACK/CSI 1/CSI 2 bits.
Parameters:
<PuschUciAckBit> float
Range: 0 to 128
Increment: 1
*RST: 0
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Number of ACK Bits" on page 95
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI1:PATTern <CSI1Pattern>,
<CSI1Bitcount>
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:CSI2:PATTern <CSI2Pattern>,
<CSI2Bitcount>
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:UCI:ACK:PATTern <AckPattern>,
<AckBitcount>
Sets the ACK/CSI 1/CSI 2 bits in pattern form.
Parameters:
<AckPattern> numeric
Bit pattern
*RST: #H0
<AckBitcount> integer
Pattern length, should be the same as the length set with the
command [:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:
SUBF<st0>:USER<dir0>:BWPart<gr0>:ALLoc<user0>:
PUSCh:UCI:ACK:BITS.
Range: 0 to 128
*RST: 0
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "ACK Pattern" on page 95
PDSCH/PUSCH Commands