Rohde & Schwarz SMW-K144 - 6 Signal Control and Signal Characteristics; 6.1 Trigger Settings

Signal Control and Signal Characteristics
R&S
®
SMW-K144
124User Manual 1178.8013.02 ─ 06
6 Signal Control and Signal Characteristics
This section lists settings provided for improving the signal and spectrum characteris-
tics of the generated signal, defining the signal power and the signal generation start.
It covers the following topics:
● Trigger Settings.....................................................................................................124
● Marker Settings.....................................................................................................130
● Clock Settings....................................................................................................... 132
● Local and Global Connector Settings....................................................................133
● Output Settings..................................................................................................... 133
● Time Domain Windowing Settings........................................................................ 136
● Adjusting the Signal Power................................................................................... 137
6.1 Trigger Settings
Access:
► Select "5G New Radio > Trigger In".
This tab provides access to the settings necessary to select and configure the trig-
ger, like trigger source and mode, and to arm or trigger an internal trigger manually.
The current signal generation status is displayed in the header of the tab together
with information on the enabled trigger mode. As in the "Marker" and "Clock" tabs,
this tab provides also access to the settings of the related connectors.
This section focuses on the available settings.
For information on how these settings affect the signal, refer to section "Basics on ..."
in the R&S SMW user manual.
Trigger Settings