Rohde & Schwarz SMW-K144 - MCS Table Transform Precoding; PUSCH UCI Settings; State

5G New Radio Configuration and Settings
R&S
®
SMW-K144
78User Manual 1178.8013.02 ─ 06
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DSID on page 210
MCS Table ← PUSCH settings
Sets the MCS table and thus together with the parameter "MCS Table Transform Pre-
coding" on page 78 defines the used modulation scheme.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:MCSTable on page 209
MCS Table Transform Precoding ← PUSCH settings
Together with the selected "MCS Table", this parameter defines the used modulation
scheme.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:MTTPrecoding on page 209
PUSCH UCI settings
Access: "User/BWP Settings > UL BWP Config > PUSCH UCI".
Here you can define the PUSCH uplink control information (UCI) parameters, such as
the settings of the uplink shared channel (UL-SCH), HARQ control information, and the
channel state information (CSI).
State ← PUSCH UCI settings
Enables the transmission and the configuration of the uplink control information (UCI).
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
STATe on page 210
Users/BWPs Settings