Rohde & Schwarz SMW-K144 - Carrier Commands

Remote-Control Commands
R&S
®
SMW-K144
166User Manual 1178.8013.02 ─ 06
Example: See Example "Loading predefined test signals" on page 148.
Usage: Query only
Manual operation: See "Test Models" on page 25
[:SOURce<hw>]:BB:NR5G:STATe <State>
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Storing current configuration" on page 147.
Manual operation: See "State" on page 23
[:SOURce<hw>]:BB:NR5G:WAVeform:CREate <Filename>
Stores the current settings as an ARB signal in a waveform file (*.wv).
Parameters:
<Filename> string
Filename or complete file path; file extension is assigned auto-
matically
Example: See Example "Storing current configuration" on page 147.
Manual operation: See "Generate Waveform File" on page 24
[:SOURce]:BB:NR5G:VERSion?
Queries the version of the 3GPP standard underlying the definitions.
Return values:
<Version> string
Example:
SOURce1:BB:NR5G:VERSion?
Usage: Query only
8.3 Carrier Commands
[:SOURce<hw>]:BB:NR5G:NODE:NCARrier.....................................................................167
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CELLid......................................................167
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CINDicator.................................................167
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:N1ID?....................................................... 167
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:N2ID?....................................................... 167
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:CARDeply................................................. 168
Carrier Commands