Rohde & Schwarz SMW-K144 - Codebook Subset; Use PUSCH Scrambling ID; Data Scrambling ID

5G New Radio Configuration and Settings
R&S
®
SMW-K144
77User Manual 1178.8013.02 ─ 06
"Off"
Disables the DFT-s-OFDM precoding operation.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:TPSTate on page 208
Max Rank ← PUSCH settings
Sets the higher layer parameter maxRank that defines the rank of the precoding
matrix, as defined in TS 38.212.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:MRANk on page 208
TxConfig ← PUSCH settings
Sets the higher layer parameter txConfig. It defines if codebook-based or non-code-
book-based transmission is used and thus defines how and which precoding matrix is
used, as defined in TS 38.212.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:TXConfig on page 208
Codebook Subset ← PUSCH settings
In case of codebook-based transmission ("TxConfig > Codebook"), sets the higher
layer parameter codebookSubset, as defined in TS 38.212.
"Fully-and-partial-and-non-coherent"
codebookSubset = fullyAndPartialAndNonCoherent
"Partial-non-coherent"
codebookSubset = partialAndNonCoherent
"Non-coherent"
codebookSubset= nonCoherent
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:CBSubset on page 209
Use PUSCH Scrambling ID ← PUSCH settings
Defines the value of the variable n
ID
used for the initialization of the generator of the
PUSCH scrambling sequence.
"Off"
n
ID
= N
ID
cell
(i.e. the physical layer cell identity)
"On"
n
ID
is the values set with the parameter Data Scrambling ID.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:SCRambling:STATe on page 209
Data Scrambling ID ← PUSCH settings
If Use PUSCH Scrambling ID > "On", sets the identifier
dataScramblingIdentityPDSCH used to initialize data scrambling (c_init) for
PUSCH.
Users/BWPs Settings