Rohde & Schwarz SMW-K144 - Mode

5G New Radio Configuration and Settings
R&S
®
SMW-K144
79User Manual 1178.8013.02 ─ 06
Mode ← PUSCH UCI settings
Defines the information transmitted on the PUSCH.
"UCI+UL-SCH"
Control information and data are multiplexed into the PUSCH.
"UCI only"
Only uplink control information is transmitted on PUSCH.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
MODE on page 211
Scaling Alpha ← PUSCH UCI settings
Sets the higher-layer parameter scaling. It defines the value of the parameter ⍺
required for the calculation of the number of coded modulation symbols per layer for
HARQ-ACK and CSI transmissions.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
ALPHa on page 211
I_CSI1_Offset,x, I_CSI2_Offset,x ← PUSCH UCI settings
According to TS 38.213, the number of resources for multiplexing the CSI information
in a PUSCH is defined by the CSI part 1 and CSI part 2 information offsets β
CSI-1
offset
and β
CSI-2
offset
.
The information offsets are defined by the indexes I
CSI-1
soffset,x
and I
CSI-2
offset,x
, where :
●
x = 0, 1 and
●
I
CSI-1
offset,0
and I
CSI-2
offset,0
is used if up to 11 CSI bits are multiplexed
●
I
CSI-1
offset,1
and I
CSI-2
offset,2
is used for more than 11 CSI bits
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF10 on page 212
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF11 on page 212
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF20 on page 212
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF21 on page 212
I_HARQ_Offset,x ← PUSCH UCI settings
According to TS 38.213, the number of resources for multiplexing the HARQ-ACK
information in a PUSCH is defined by the information offsets β
HARQ-ACK
offset
.
The information offsets are defined by the indexes I
HARQ-ACK
offset,x
, where :
●
x = 0, 1, 2 and
●
I
HARQ-ACK
offset,0
is used if up to 2 HARQ-ACK information bits are multiplexed
●
I
HARQ-ACK
offset,1
is used for multiplexing of 2 to 11 HARQ-ACK information bits
●
I
HARQ-ACK
offset,2
is used if more than 11 HARQ-ACK information bits are multiplexed
Users/BWPs Settings