5G New Radio Configuration and Settings
R&S
®
SMW-K144
29User Manual 1178.8013.02 ─ 06
5.2.1 Scheduling
Access:
1. Select "5G New Radio > Link > Downlink".
2. Select "5G New Radio > General > Node > Scheduling".
Settings:
PDSCH Scheduling.......................................................................................................29
Restrict to Search Space.............................................................................................. 29
PDSCH Scheduling
Defines whether the PDSCH Scheduling is performed manually or according to the
configuration made for the DCIs.
"Manual"
This is the default scheduling mode and the mode with full flexibility;
you can configure any of the available settings.
There is no cross-reference between the settings made for the COR-
ESET DCIs and the PDSCHs settings. You are responsible for the
content of the PDSCH allocations.
"Auto/DCI"
This mode assures a 3GPP compliant signal; the PDSCH allocations
are configured automatically according to the configuration of the
CORESET DCIs.
The following settings are configured automatically:
●
"Users/BWPs > Properties" > DSCH Channel Coding = "On"
●
"Scheduling > CORESET > Custom DCI" > Channel Coding =
"On"
●
For all DCI 1_1 and 1_0 in "Scheduling > CORESET > DCI
Table", Create PDSCH = "On"
●
In the "Scheduling" dialog, you can configure only Content =
"CORSET" (the PDSCH allocations are configured automatically).
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHeduling:MODE on page 213
Restrict to Search Space
The term search space describes a set of CCEs that a UE monitors. The UE can
decode only the control information on a PDCCH/CORESET that is transmitted over
CCEs within the search space this UE monitors.
This parameter defines how the search space and the CCE idexes are defined.
Together with other parameters it influences the way the search space is defined. For
details, see "Search Space" on page 103.
Node Settings
To Next Page
Loading...