Rohde & Schwarz SMW-K144 - Page 109

5G New Radio Configuration and Settings
R&S
®
SMW-K144
109User Manual 1178.8013.02 ─ 06
Content ← DCI Table
Access a dialog for configuring the parameters per DCI format, see "DCI Content Con-
figuration" on page 109
Create PDSCH ← DCI Table
If enabled, the content and scheduling of the PDSCH is created automatically, as con-
figured with the DCI format 1_0 and 1_1 parameters.
If PDSCH Scheduling = "Auto/DCI", the "Create PDSCH" = "On".
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:CPDSch on page 239
DCI Content Configuration
Comprises the parameters of the selected DCI format.
The fields defined in the DCI format are mapped to the information bits according to TS
38.212. The resulting Bit Data > Pattern is displayed.
The following parameters have an impact on the DCI bit data length and the DCI fields:
●
Number of RB No. RBs of the first UL BWP
●
Number of RB of the DL BWP, in that the DCi is configured
●
SUL indicator of the selected cell
●
DCI Search Space
Bit Data > Pattern ← DCI Content Configuration
Displays the resulting bit data as selected with the DCI format parameters.
Mapping of the information bits is according to TS 38.212.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:HBTS? on page 239
DCI Format 0_0 ← DCI Content Configuration
The DCI format 0_0 is used for scheduling of PUSCH in one UL cell.
DCI format 0_0 is scrambled by C-RNTI or CS-RNTI and carries the following informa-
tion:
CORESET Settings