Rohde & Schwarz SMW-K144 - Page 54

5G New Radio Configuration and Settings
R&S
®
SMW-K144
54User Manual 1178.8013.02 ─ 06
Remote command:
via suffix at USER<ch>
Cell
Selects/indicates to which carrier/cell the settings apply.
Remote command:
via suffix at CELL<ch>
Number of DL/UL BWPs
Sets the number of downlink bandwidth parts (BWP).
There is one table row per enabled DL/UL BWP.
See also Figure 5-1.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:NBWParts
on page 186
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:NBWParts
on page 186
BWPs table
Comprises the BWPs settings.
There is one table row per enabled DL/UL BWP, see "Number of DL/UL BWPs"
on page 54.
BWP Indicator ← BWPs table
Sets the unique indicator for the selected BWP, used to address the BWP within the
DCI.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
INDicator on page 186
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
INDicator on page 186
SC Spacing/CP ← BWPs table
Selects a combination of the subcarrier spacing (SCS) and the cyclic prefix (CP),
where the available values depend on the "Deployment".
See Table 3-2.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
SCSPacing on page 186
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
SCSPacing on page 186
No. RBs ← BWPs table
Defines the number of resource blocks (RB) the bandwidth part (BWP) occupies. This
value defines the frequency width of the BWP.
Users/BWPs Settings