Signal Control and Signal Characteristics
R&S
®
SMW-K144
132User Manual 1178.8013.02 ─ 06
Marker x Delay
Delays the marker signal at the marker output relative to the signal generation start.
Variation of the parameter "Marker x Delay" causes signal recalculation.
Remote command:
[:SOURce<hw>]:BB:NR5G:TRIGger:OUTPut<ch>:DELay on page 267
6.3 Clock Settings
Access:
► Select "5G New Radio > Clock".
This tab provides access to the settings necessary to select and configure the
clock signal, like the clock source and clock mode.
This section focuses on the available settings.
For information on how these settings affect the signal, refer to section "Basics on ..."
in the R&S SMW user manual.
Defining the Clock
The provided clock signals are not dedicated to a particular connector. They can be
mapped to one or more USER x and T/M/C connectors.
Use the Local and Global Connector Settings to configure the signal mapping, the
polarity, the trigger threshold, and the input impedance of the input connectors.
To route and enable a trigger signal, perform the following general steps:
●
Define the signal source, that is select the "Clock > Source".
●
Define the connector where the selected signal is provided.
Use the Local and Global Connector Settings.
Settings:
Clock Source...............................................................................................................132
Clock Mode................................................................................................................. 133
Measured External Clock............................................................................................133
Clock Source
Selects the clock source.
●
"Internal"
Clock Settings
To Next Page
Loading...