Rohde & Schwarz SMW-K144 - CORESET Commands

Remote-Control Commands
R&S
®
SMW-K144
230User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:APMap:COL<s2us0>:ROW<s3us0>:
MAGNitude <APMapDataMagn>
Defines the mapping of the antenna ports to the physical antennas, cylindrical mapping
coordinates are used.
Parameters:
<APMapDataMagn> float
Range: 0 to 1
Increment: 0.001
*RST: 0
Example: See [:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:
SUBF<st0>:USER<dir0>:BWPart<gr0>:ALLoc<user0>:
APMap:COL<s2us0>:ROW<s3us0>:PHASe on page 230.
Manual operation: See "Mapping Table" on page 99
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:APMap:COL<s2us0>:ROW<s3us0>:PHASe
<APMapDataPhase>
Defines the mapping of the antenna ports to the physical antennas, if cylindrical map-
ping coordinates are used.
Parameters:
<APMapDataPhase> float
Range: 0 to 360
Increment: 0.1
*RST: 0
Example:
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER0:
BWPart0:ALLOc1:APMap:MAPCoordinates CYL
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER0:
BWPart0:ALLOc1:APMap:COL0:ROW0:PHASe 0
SOURce1:BB:NR5G:SCHed:CELL0:SUBF0:USER0:
BWPart0:ALLOc1:APMap:COL0:ROW0:MAGNitude 1
Manual operation: See "Mapping Table" on page 99
8.13 CORESET Commands
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:PREGran.................................................................................233
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:ID........................................................................................... 233
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:DMRS:SCRam:STATe...............................................................233
CORESET Commands