Rohde & Schwarz SMW-K144 - Page 233

Remote-Control Commands
R&S
®
SMW-K144
233User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:DCI<s2us0>:CBGFi.................................................................. 247
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:DCI<s2us0>:STATe...................................................................247
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:DCI<s2us0>:DATA....................................................................248
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:DCI<s2us0>:DLISt....................................................................248
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:DCI<s2us0>:BITLength.............................................................248
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CS:DCI<s2us0>:PATTern................................................................249
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:PREGran <PrecoderGranula>
Sets the value of the higher-layer parameter precoderGranularity, as defined in
TS 38.211.
Parameters:
<PrecoderGranula> REG | ACRB
REG
REG bundle (sameAsREG-bundle)
ACRB
All contiguous RBs (allContiguousRBs)
*RST: REG
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Precoder Granularity" on page 101
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:ID <ID>
Sets the CORESET ID.
Parameters:
<ID> integer
Range: 0 to 11
*RST: 1
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "CORESET ID" on page 102
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DMRS:SCRam:STATe <CSDmrsScramStat>
If enabled, the DMRS ID is used to calculate the PUCCH scrambling sequence.
CORESET Commands