Rohde & Schwarz SMW-K144 - SRS Commands; Scheduling Commands

Remote-Control Commands
R&S
®
SMW-K144
212User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF10 <PuschUciCsiOf10>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF11 <PuschUciCsiOf11>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF20 <PuschUciCsiOf20>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:UCI:
CSI:OF21 <PuschUciCsiOf21>
Sets the CSI part 1 (OF10|OF11) and CSI part 2 (OF20|OF21) information offsets,
where the OF10|OF20 are used if up to 11 CSI bits are multiplexed and OF11|OF21
otherwise.
Parameters:
<PuschUciCsiOf21> integer
Range: 0 to 18
*RST: 0
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "I_CSI1_Offset,x, I_CSI2_Offset,x" on page 79
8.10.7 SRS Commands
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:SRS:NAPort......212
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:SRS:
NAPort <SrsNumAp>
Sets the number of antenna ports used for every SRS transmission.
Parameters:
<SrsNumAp> AP2 | AP4 | AP1
*RST: AP1
Example:
SOURce1:BB:NR5G:UBWP:USER0:CELL0:UL:BWP0:SRS:NAPort AP4
Manual operation: See "Number of SRS Antenna Ports" on page 80
8.11 Scheduling Commands
[:SOURce<hw>]:BB:NR5G:SCHeduling:MODE.................................................................213
[:SOURce<hw>]:BB:NR5G:SCHeduling:RSSPace.............................................................213
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:CONTent.......................................................................................214
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
NALLoc...............................................................................................................214
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:SLOT............................................................................................214
Scheduling Commands