Rohde & Schwarz SMW-K144 - Payload Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
120User Manual 1178.8013.02 ─ 06
OCC Length
For PUCCH format F4, sets the value of the parameter N
SF
PUCCH,4
and thus defines
which of the orthogonal sequences w
n
(m) defined in TS 38.211 is used.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:FS:OCCLength on page 252
OCC Index
For PUCCH format F4, sets the orthogonal sequence index n (n = 0 to 4). As defined
in TS 38.211, the value is required to select the orthogonal sequence, used for the
block-wise spreading.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUCCh:FS:OCCindex on page 251
5.7.2 Payload Settings
Access:
1. Select "Scheduling > User x BWP x > Content > PUCCH > Settings > Config".
2. Select "Payload".
Settings:
Positive SR Count.......................................................................................................120
Number of ACK Bits....................................................................................................121
ACK Pattern................................................................................................................ 121
Number of UCI Bits..................................................................................................... 121
UCI Pattern................................................................................................................. 121
Positive SR Count
Sets the number of positive scheduling requests (SR). The value is used to define the
mapping of the HARQ-ACK and CSI bits. For details, see TS 38.213.
PUCCH Settings