Remote-Control Commands
R&S
®
SMW-K144
249User Manual 1178.8013.02 ─ 06
Manual operation: See "Pattern Length" on page 117
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:CS:DCI<s2us0>:PATTern <Pattern>,
<BitCount>
Sets the content of the custom DCI as a bit pattern.
Parameters:
<Pattern> 128 bits
Corresponds to the value set with the command [:
SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:
USER<dir0>:BWPart<gr0>:ALLoc<user0>:CS:
DCI<s2us0>:BITLength.
*RST: #H0
<BitCount> Range: 1 to 128
*RST: 1
Example: See Example "Configuring the CORESET settings"
on page 157.
Manual operation: See "Data Source" on page 116
8.14 PUCCH Commands
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:GRPHopping..................................................................... 250
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:HOPid...............................................................................250
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:ISFHopping....................................................................... 250
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:SHOPping.........................................................................251
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:FS:CYCShift......................................................................251
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:FS:TDOCc........................................................................ 251
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:FS:OCCindex.................................................................... 251
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:FS:OCCLength.................................................................. 252
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:PL:SRCount...................................................................... 252
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:PL:UCI:BITS......................................................................252
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:BWPart<gr0>:
ALLoc<user0>:PUCCh:PL:ACK:BITS.....................................................................252
PUCCH Commands