Rohde & Schwarz SMW-K144 - Channel Coding Settings

5G New Radio Configuration and Settings
R&S
®
SMW-K144
92User Manual 1178.8013.02 ─ 06
Length
Defines whether single- or double-symbol DMRS is used.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh|PUSCh:DMRS:LENGth on page 222
Slot Symbols
Indicates the number of DMRS slot symbols. The value is set automatically, depending
on the selected "Length".
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh|PUSCh:DMRS:SLTSymbols? on page 223
Power
Sets the power of the PDSCH/PUSCH, relative to the power of the other channels.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh|PUSCh:DMRS:POWer on page 223
5.5.4 Channel Coding Settings
Access:
1. Select "5G New Radio > General > Users/BWPs > Properties > DSCH/USCH
Channel Coding > On".
2. Select "Scheduling > User x BWP x > Content > PDSCH/PUSCH > Settings > Con-
fig".
3. Select "Channel Coding".
The dialog comprises the settings for the LDPC channel coding for PDSCH and
PUSCH.
PDSCH/PUSCH Settings