Rohde & Schwarz SMW-K144 - Page 222

Remote-Control Commands
R&S
®
SMW-K144
222User Manual 1178.8013.02 ─ 06
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh|PUSCh:DMRS:SEQGen <SeqGen>
Sets how the scrambling ID for DMRS is derived.
Parameters:
<SeqGen> DMRSid | CELLid
DMRSid
N
ID
DMRS
: Scrambling ID (i.e. n
ID
) = DMRS scrambling ID (i.e.
N
ID
DMRS
)
CELLid
N
ID
Cell
: Scrambling ID (i.e. n
ID
) = cell ID (i.e. N
ID
Cell
)
*RST: CELLid
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Sequence Generation" on page 91
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh|PUSCh:DMRS:NSID <NScid>
Sets the scrambling ID (N
ID
).
Parameters:
<NScid> integer
Range: 0 to 1
*RST: 0
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "N_SCID" on page 91
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh|PUSCh:DMRS:LENGth <DmrsLen>
Defines whether single- or double-symbol DMRS is used.
Parameters:
<DmrsLen> integer
Range: 1 to 2
*RST: 1
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Length" on page 92
PDSCH/PUSCH Commands