Rohde & Schwarz SMW-K144 - Page 221

Remote-Control Commands
R&S
®
SMW-K144
221User Manual 1178.8013.02 ─ 06
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Number of Codewords" on page 88
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh:SBCZero:STATe <UserAllocPdschS>
Sets if the PDSCH settings are scheduled by CORESET 0 or not.
Parameters:
<UserAllocPdschS> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Scheduled by CORESET 0" on page 89
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>[:CW<s2us0>]:MOD <Modulation>
Sets the modulation scheme.
Parameters:
<Modulation> BPSK | BPSK2 | QPSK | QAM16 | QAM64 | QAM256
Supported modulations depend on the channel.
*RST: BPSK
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Modulation" on page 89
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>[:CW<s2us0>]:PHYSbits?
Queries the size of the selected allocation in bits.
Return values:
<AllocPhysBits> integer
Range: 0 to 65535
*RST: 0
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Usage: Query only
Manual operation: See "Phys. Bits" on page 89
PDSCH/PUSCH Commands