Rohde & Schwarz SMW-K144 - Offset Relative To;Ss;Pbch Patterns Table

5G New Radio Configuration and Settings
R&S
®
SMW-K144
36User Manual 1178.8013.02 ─ 06
Offset Relative to...........................................................................................................36
SS/PBCH patterns table................................................................................................37
└ SC Spacing/CP...............................................................................................37
└ RB Offset/RB Offset (15 kHz SCS)/RB Offset (60 kHz SCS)......................... 37
└ SC Offset/SC Offset (15 kHz SCS)/SC Offset (60 kHz SCS)......................... 38
└ Delta f to Carrier (Centers)..............................................................................38
└ Case................................................................................................................38
└ L......................................................................................................................39
└ Positions......................................................................................................... 39
└ Burst Set Periodicity........................................................................................39
└ PBCH Config...................................................................................................40
└ PSS/SSS Power............................................................................................. 40
└ PBCH Power...................................................................................................40
└ State................................................................................................................40
Cell
Selects/indicates to which carrier/cell the settings apply.
Remote command:
via suffix at CELL<ch>
Antenna Port
Indicates that antenna port 4000 is used.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CARMapping:AP4000[:ROW<ch0>]
on page 183
Number of SS/PBCH Patterns
Defines how many patterns for the synchronization signals and the PBCH are config-
ured. There is one table row per pattern.
See also Chapter 3.7, "Synchronization Signals and SS/PBCH Block", on page 17.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:NSSPbch on page 173
Offset Relative to
Defines the reference point, relative to which the SS/PBCH is allocated in frequency
domain.
"TxBW"
The frequency position of the SS/PBCH is set relative to the usable
RBs that apply for the current numerology, i.e. to the start of the
TxBWs.
If this reference point is used, you can select the SC Spacing/CP for
that the following apples:
●
TxBW spans at least 20 RBs (i.e. N_RB > 20)
●
TxBW is enabled for this SCS (i.e. Use > "On".
"Point A"
The frequency position of the SS/PBCH is set relative to the position
of point A.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:OFFSet on page 172
Node Settings