5G New Radio Configuration and Settings
R&S
®
SMW-K144
39User Manual 1178.8013.02 ─ 06
SS/PBCH case SCS Frequency
Case D 120 KHz > 6 GHz
Case E 240 KHz > 6 GHz
*)
The start symbol index in case B and case C is different.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:CASE on page 174
L ← SS/PBCH patterns table
Sets the number of SS/PBCH blocks, transmitted per burst.
This value sets the pattern length, used to define the Positions of the transmitted SS/
PBCH blocks.
The available values for "L" depend on the selected Deployment as follows:
●
"Deployment" = "f ≤ 3 GHz": L = 4 or 8, where
L = 8 is supported for the unpaired spectrum below 3 GHz if Case = "C"
●
"Deployment" = "3 GHz < f ≤ 6 GHz": L = 8
●
"Deployment" = "f > 6 GHz": L = 64
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:L on page 175
Positions ← SS/PBCH patterns table
A half-frame contains 4, 8 or 64 SS/PBCH blocks, depending on the selected subcar-
rier spacing and deployment and as set with the parameter L. The group of 4, 8 or 64
blocks is referred to as burst set, see Figure 3-3.
This parameter defines which of these theoretically possible maximum numbers of SS/
PBCH blocks are transmitted in each burst set. The definition is a pattern, where:
●
Pattern length = 4, 8 or 64 and corresponds to the maximum number of SS/PBCH
blocks
●
Each bit applies to one SS/PBCH block
●
1: SS/PBCH block is present
●
0: SS/PBCH transmission is suppressed.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:POSition
on page 175
Burst Set Periodicity ← SS/PBCH patterns table
Defines how often a SS/PBCH burst set is transmitted.
The "Burst Set Periodicity = 10", for example, corresponds to a transmission in every
frame.
See also Figure 3-3.
Remote command:
[:SOURce<hw>]:BB:NR5G:NODE:CELL<ch0>:SSPBch<st0>:BSPeriodicty
on page 175
Node Settings
To Next Page
Loading...